최신 CLSSBB-001 무료덤프 - GAQM Certified Lean Six Sigma Black Belt (CLSSBB)
Which statement(s) are incorrect for the Regression Analysis shown here? (Note: There are 2 correct answers).
정답: B,D
Calculate the Rolled Throughput Yield of this process using this data.
Data: unit input: 1215, unit output: 1180, defects repaired: 184, scrap: 42
Data: unit input: 1215, unit output: 1180, defects repaired: 184, scrap: 42
정답: B
Contingency Tables are used to test for association, or dependency, between two or more classifications.
정답: A
The _____________ Distribution would be the most desirable for modeling the number of stitch defects in a portion of fabric.
정답: D
How many experimental runs exist in a Full Factorial and fully randomized design for 5 factors with 2 replicates for the Corner Points and no Center Points? The factors in the experiment are only at 2-levels.
정답: C
When a Belt properly analyzes the results of an experiment he must examine the Residuals in expectation of finding all of the following except _________.
정답: C
The primary objective in removal of waste is to improve the Order Production Cycle where the time from _________________ to the time of receipt of payment is compressed.
정답: C
Which statement is NOT correct about the Fitted Line Plot shown here?
정답: A
When conducting a Hypothesis Test using Continuous Data the proper sample size is influenced only by the extent to which we need to assess a Difference to be detected but not the inherent variation in the process.
정답: B
If a Six Sigma project was to reduce repair station inventory and the team found the inventory was creeping up over time which Lean tools should be considered in the Control Phase to reestablish and sustain the project success?
정답: B
To properly analyze the variables impacting the output of a process we need to collect data that represents at least 80% of the variation in the process and assure ourselves we are collecting data from all three types of variation which are _______________.
정답: C
Statistical Difference is the magnitude of difference or change required to distinguish between a true difference, brought about by change or improvement, and one that could have occurred by chance.
정답: A
Which of these might contribute to similar distributions having Unequal Variance?
정답: B
Range Charts are the technique used to determine if ______________ are occurring within the subgroups of the SPC Charts.
정답: A
A Belt is analyzing data and upon creation of the graphical analysis sees multiple modes. One of the primary reasons this could occur is because the process has experienced a ____________________.
정답: D
Using this partial Z Table, how many units from a month's production run are expected to not satisfy customer requirements for the following process?
Upper specification limit: 7.2 Lower specification limit: 4.3 Mean of the process: 5.9 Standard Deviation: 0.65 Monthly production: 450 units
Upper specification limit: 7.2 Lower specification limit: 4.3 Mean of the process: 5.9 Standard Deviation: 0.65 Monthly production: 450 units
정답: D
Which statement(s) are correct about the Regression shown here? (Note: There are 2 correct answers).
정답: A,C
Early in a project a Belt will want to begin to identify and evaluate risk factors for the subject process and will therefore begin building a(n) ______________.
정답: A