최신 NSE7_EFW-7.2 무료덤프 - Fortinet NSE 7

문제1

Refer to the exhibit, which contains a partial BGP combination.

You want to configure a loopback as the OGP source.
Which two parameters must you set in the BGP configuration? (Choose two)

A. ebgp-enforce-multihop

B. recursive-next-hop

C. update-source

D. ibgp-enfoce-multihop

정답: A,C

설명: (DumpTOP 회원만 볼 수 있음)

문제2

Refer to the exhibit, which contains a TCL script configuration on FortiManager.

An administrator has configured the TCL script on FortiManager, but the TCL script failed to apply any changes to the managed device after being run.
Why did the TCL script fail to make any changes to the managed device?

A. The TCL procedure lacks the required loop statements to iterate through the changes.

B. The TCL procedure run_cmd has not been created.

C. There is no corresponding #! to signify the end of the script.

D. The TCL script must start with #include.

정답: B

문제3

Which statement about the designated router (DR) and backup designated router (BDR) in an OSPF multi- access network is true?

A. Non-DR and non-BDR routers form full adjacencies to DR only.

B. Non-DR and non-BDR routers send link state updates and acknowledgements to 224.0.0.6.

C. Only the DR receives link state information from non-DR routers.

D. FortiGate first checks the OSPF ID to elect a DR.

정답: A

문제4

Refer to the exhibit which shows an OSPF network.

Which types of link-state advertisements (LSA) will NGFW-1 send if it is a backup designated router (BDR)

A. NGFW-1 will send type 1 and type 3 LSAs

B. NGFW-1 will send type 1 and type 5 LSAs

C. NGFW-1 will send type 1 and type 2 LSAs

D. NGFW-1 will send type 1 and type 4 LSAs.

정답: A

문제5

What is true about the Fitter override option in the application control profile?

A. Helps to control specific signature and applications

B. Helps to configure actions for predefined categories

C. Helps to categorize applications based on behavior risk or on technology

D. Helps to view the application control signatures for a specific category

정답: C

문제6

Refer to the exhibit.

The partial interlace configurator! of two FortiGate devices is shown
Which two conclusions can you draw from this configuration? (Choose two.)

A. In VRRP, you are restricted to add a third FortiGate into VRRP group 1.

B. At the time of failover, FortiGate_A will change its priority to 30

C. By default, preemption mode is enabled

D. You can include 4.4.4.4 and 4.4.4.2 IP addresses using sat vrdst command

정답: B,C

문제7

Refer to the exhibit, which shows a routing table.

What two options can you configure in OSPF to block the advertisement of the 10.1.10.0 prefix? (Choose two.)

A. Remove the 16.1.10.C prefix from the OSPF network

B. Configure a route-map out

C. Disable Redistribute Connected

D. Configure a distribute-list-out

정답: B,D

설명: (DumpTOP 회원만 볼 수 있음)

문제8

Refer to the exhibit, which shows information about an OSPF interface
What two conclusions can you draw from this command output? (Choose two.)

A. NGFW-1 forms neighbor adjacency only with DR and BDR router.

B. NGFW-1 sends its LSA updates to 224.0.0.6 address

C. NGFW-1 sends its LSA updates to 224.0.0. 5 address

D. NGFW-1 forms neighbor adjacency only if other OSPF routers match the wait time of 40 seconds

정답: A,B

최신 NSE7_EFW-7.2 무료덤프 - Fortinet NSE 7 - Enterprise Firewall 7.2

우리와 연락하기

유용한 링크

최신 업데이트