최신 NCSC-Level-1 무료덤프 - Nutanix Certified Services Consultant (NCSC): Level 1

문제1

While trying to upgrade AOS in a cluster, a consultant receives a warning message that there are two powered-on VMs that need to be powered off for the upgrade to proceed.
What would cause this warning to be issued?

A. Upgrading a two-node cluster requires the VMs to be shut down.

B. There are not enough resources left in the two-node cluster.

C. Upgrading a single-node cluster requires the VMs to be shut down.

D. There are not enough resources left in the single-node cluster.

정답: C

문제2

A consultant creates a new cluster using ESXi as the hypervisor. After creating the cluster, the consultant begins to run Life Cycle Manager (LCM) updates. During the LCM upgrade pre-checks, an error is returned.
Which configuration is causing this issue?

A. ESXi cluster DRS is enabled.

B. ESXi cluster admission control is disabled.

C. ESXi cluster HA is enabled.

D. ESXi cluster admission control is enabled.

정답: D

문제3

A consultant needs to review a customer's switch port configuration to identify any issues. Other customer requirements are as follows:
* Leverage LACP
* Native VLAN will not be used
* Use Multiple Upstream switches
* Use VLANs 20-25 and 30
* LACP Fallback has been Enabled
* vPC or MLAG has been configured
What must be included in a configuration in order to meet these requirements?

A. Native VLAN set to 30
Ports Trunked to allow all necessary VLANs

B. Native VLAN set to default
Ports trucked to allow all necessary VLANs

C. Native VLAN set to default
Ports in access mode to allow all necessary VLANs

D. Native VLAN set to 30
Ports in access mode to allow all necessary VLANs

정답: B

문제4

Where in the Support Portal is the Best Practices guide for vSphere Networking located?

A. Product Notices

B. Software Documentation

C. Solutions Documentation

D. Knowledge Base

정답: C

문제5

What is the minimum number of nodes required for a Nutanix Cluster to support Replication Factor 3 (RF3) on a storage container?

A. 6

B. 4

C. 3

D. 5

정답: D

문제6

A customer has engaged a Nutanix consultant to deploy a cluster consisting of two NX-3460-G6 blocks. The consultant arrives at the customer site and fines the following:
* One rack with a total of 5U available
* Two ToR switches with 14 total available ports
* Dual PDUs with six available sockets
What will prevent the consultant from successfully installing the cluster?

A. Insufficient sockets for power allocation.
Rack space may not be continuous.

B. Insufficient network ports for communication.
Rack space may not be continuous.

C. Insufficient network ports for communication.
Insufficient sockets for power allocation.

D. Insufficient rack space for block installation.
Insufficient sockets for power allocation.

E. Insufficient network ports for communication.
Insufficient sockets for power allocation.

정답: D

문제7

A customer has an ESXi Cluster with two 10GbE NICs on each node with the following requirements:
* Solution must follow Nutanix Best Practices
* Network configuration should be redundant
* A vSphere Standard Switch must be utilized
Which load balancing method should be used?

A. Route based on source MAC hash

B. Route based on IP hash

C. Route based on originating port ID

D. Route based on physical NIC load

정답: C

문제8

A consultant is using the Foundation applet to create a cluster. During the process the consultant refreshes the progress bar web page and is concerned when nothing loads.
What should the consultant do to verify that Foundation has completed successfully?

A. Connect to any CVM IP address from a web browser.

B. Return to the Foundation configuration page and start over.

C. Update Java on the Foundation VM.

D. Restart the Foundation process.

정답: A

최신 NCSC-Level-1 무료덤프 - Nutanix Certified Services Consultant (NCSC): Level 1

우리와 연락하기

유용한 링크

최신 업데이트