최신 NACE-CIP1-001 무료덤프 - NACE Coating Inspector Level 1

문제1

Checking is

A. a very small hole in a coating caused when air or solvent is trapped in porous film and then escapes.

B. a fine crack in the surface of a coating that rarely reaches the substrate

C. an exposed area of the substrate or previous coat material, caused by poor application technique.

D. surface breaks in the film that often result from grease or oil contamination and revel the substrate.

정답: B

문제2

To be of value the Inspector's documentation must be:

A. Submitted before the end of the job

B. Timely, accurate and concise

C. Always handwritten

D. Always typewritten

정답: B

문제3

You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

A. 45 Gauge readings resulting in 15 Spot Measurements

B. 225 Gauge Readings resulting in 75 Spot Measurements

C. 75 Gauge Readings resulting in 25 Spot Measurements

D. 105 Gauge Readings resulting in 35 Spot Measurements

정답: B

문제4

In the event of a conflict between the project specification and the coating manufactures' product data sheet, the Inspector's first course of action should be too:

A. Call the person who wrote the specification for clarification

B. Call the coating manufacturer for clarification

C. Use the job specification as a guide

D. Use the product data sheet as a guide

정답: C

문제5

Whenever dissimilar metals must join, the most common practice is to

A. provide anodic protection to prevent corrosion.

B. provide cathodic protection to prevent corrosion,

C. avoid coating all connected dissimilar metals.

D. coat all connected dissimilar metals.

정답: D

문제6

The Inspector should record the serial numbers of inspection instruments:

A. Each time the instrument is used

B. Only when verifying accuracy of the instrument

C. Only if the instrument is suspected of not working properly

D. Only if the specification requires it

정답: A

문제7

ISO SA 3 is directly equivalent to:

A. NACE No. 1/SSPC SP 5

B. NACE No. 3/SSPC SP 6

C. None of the above

D. NACE No. 2/SSPC SP 10

정답: C

문제8

Dew point is the temperature at which

A. water freezes.

B. humidity decreases

C. the air is saturated.

D. condensation occurs.

정답: D

문제9

Check abrasive blast pressure with a

A. replica tape

B. needle pressure gauge

C. surface comparator

D. nozzle aperature gauge

정답: B

문제10

NACE SP 0178 is a standard for:

A. Stainless steel pipe to be Externally Coated

B. Tanks and Vessels to, be Lined for Immersion Service

C. Tanks and Vessels to be Externally Coated

D. Structural steel to be coated for Atmospheric Service

정답: B

최신 NACE-CIP1-001 무료덤프 - NACE Coating Inspector Level 1

우리와 연락하기

유용한 링크

최신 업데이트