최신 MSC-122 무료덤프 - Motorola Solutions Deploy WLAN Solutions
As part of the Acceptance Testing you will need to validate that the failover design of your RFS controllers is working. Your configuration is two RFS7000 controllers. You decide to check your failover status by inspecting the System Status LEDs on the primary RFS7000 controller. If your system is configured and functioning correctly what is the expected current state of the System Status 2 LED? Please use the Status exhibit at the bottom.
정답: C
Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
정답: C
Following the installation of a WLAN that was originally designed and tested to support 15 concurrent client workstations, you learn that the number of users will be reduced to between 5 - 8 concurrent users.
Which of the following would result from this change in circumstance?
Which of the following would result from this change in circumstance?
정답: D
An RFS controller with directly attached APs operates at which of the following networking hierarchical layers?
정답: A
In preparation for a new voice installation, you have been tasked to design a Motorola Solutions wireless network that will provide the best quality for voice enabled handhelds. While surveying the facility, you note that the noise floor is -85dBm. The manufacturer of the handhelds recommendations a SNR of 20dB. What is the minimum coverage area signal strength that should be planned for, given the above requirements?
정답: D
You have deployed a Motorola WiNG 5 WLAN solution at the site of a new customer. Someone from the IT group of the customer will be designated the platform owner and will need to have the most robust set of administrative rights. To which administrative role would you assign to this individual?
정답: C
You just installed a WiNG 5 RFS4O00 controller and several AP650s in a small branch office and clients on the wireless network cannot connect out to the internet. You have determined that the clients are associated and connected to the APs and you can ping the RFS4000 controller from your laptop. You connect to RFS4000 serially and start to troubleshoot the issue. Which of the following CLI commands can help you determine where the issue maybe occurring?
정답: B
You are monitoring a wireless client on a WLAN and are using a 2.4GHz radio to capture a wireless trace. When using the sniffer-redirect option on Motorola AP without off-channel scanning, how many simultaneous 20Mhz channels can be redirected by the AP?
정답: B
You are installing an 802.11n wireless segment which is intended to support VoWLAN applications in the 5 GHz band. The network design document specifies that the signal strength supports at least MCS 4 and requires an SNR of 25 dB minimum. Using the chart shown in Exhibit B.3.2.09vl, and without taking into consideration additional requirements, what is the maximum noise floor that can be tolerated within these constraints?
정답: C
Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
정답: E