최신 H12-311-ENU 무료덤프 - Huawei Certified ICT Associate-Wireless Local Area Network
Capacity planning mainly estimates the number of APs needed to meet the traffic volume in terms of device performance, number of users, bandwidth requirements, and wireless environment.
정답: A
Which of the following protocols can support both the 2.4 GHz band and the 5 GHz band?
정답: D
Which of the following commands is to add GE 0/0/1 of Huawei access switch to VLAN 100?
정답: C
For outdoor WLAN coverage, the following statement is correct (Select 3 Answers).
정답: A,B,D
Which of the following rates is not the rate supported by the 802.11a protocol?
정답: D
If an enterprise wireless network networking mode is direct forwarding, the thin AP can convert the 802.11 data packet into an Ethernet packet, and then encapsulate the packet into a CAPWAP encapsulation and transmit the data packet to the AC through the CAPWAP tunnel.
정답: B
In the WLAN network configuration, what command must be executed on the AC6605 to deliver the configuration to AP1?
정답: C
Which of the following options are the basic functions for configuring Huawei wireless controllers? (Select 3 Answers)
정답: A,C,D
When deploying APs on multiple floors of a building, the factor to be aware of is (Select 3 Answers).
정답: A,B,D
The lobe width is a very important parameter commonly used in directional antennas. It refers to the angle between the antenna and the radiation pattern below the peak dB The width.
정답: C
Huawei Plug-in Controllers Which series of switches (Select 3 Answers) are available for Huawei ACU boards?
정답: A,B,D
The current version information can be viewed in the following commands.
정답: C
To create a radio-profile, you must bind wmm-profile, or you will get an error.
정답: A
Which of the following protocols are IEEE 802.11 standards Select 3 Answers)?
정답: A,C,D
What are the options that can be configured under sevice-set (Select 3 Answers)?
정답: A,B,D
Which of the following two are PoE's power supply standards (Select 2 Answers)?
정답: A,D
There are three types of Huawei load balancing judgment: traffic mode, session mode, and virtual switch mode.
정답: B
AP transmit power 20dBm, antenna gain 4dBi, cable and device loss 1dB, terminal receive antenna gain 2dBi, spatial propagation loss 80dB, terminal receive level RSSI=.
정답: D
The BSSID is actually the MAC address of the AP and is used to identify the BSS managed by the AP.
정답: B
In a point-to-multipoint networking environment, one device acts as a central device, and all other devices establish wireless bridges with the central device to interconnect multiple networks. The disadvantage is that the interworking of multiple branch networks requires data forwarding through the central bridge device.
정답: A