최신 FCSS_SDW_AR-7.4 무료덤프 - Fortinet FCSS

문제1

Refer to the exhibit. An administrator configures SD-WAN rules for a DIA setup using the FortiGate GUI. The page to configure the source and destination part of the rule looks as shown in the exhibit. The GUI page shows no option to configure an application as the destination of the SD-WAN rule Why?

A. FortiGate allows the configuration of applications as the destination of SD-WAN rules only on the CLI.

B. You cannot use applications as the destination when FortiGate is used for a DIA setup.

C. You must enable the feature on the CLI.

D. You must enable the feature first using the GUI menu System > Feature Visibility.

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

문제2

Refer to the exhibits. An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in the first exhibit. After generating GoToMeeting test traffic, the administrator examined the corresponding traffic log on FortiAnalyzer, which is shown in the second exhibit.
The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.
Which two reasons explain why some log messages show that the traffic matched the implicit SD- WAN rule? (Choose two.)

A. Full SSL inspection is not enabled on the matching firewall policy.

B. No configured SD-WAN rule matches the traffic related to the collaboration application GoToMeeting

C. The session 3-tuple did not match any of the existing entries in the ISDB application cache.

D. FortiGate could not refresh the routing information on the session after the application was detected.

정답: B,C

설명: (DumpTOP 회원만 볼 수 있음)

문제3

Refer to the exhibit. What conclusions can you draw about the traffic received by FortiGate originating from the source LAN device 10.0.1.133 and destined for the company's SMTP mail server at 10.66.0.125?

A. FortiGate steers the traffic from the LAN device 10.0.1.133 to the company SMTP mail server
10.66 0.125 through port3.

B. ForliGate steers the traffic from the LAN device 10.0.1.133 to the company SMTP mail server
10.66.0.125 through port2.

C. FortiGate steers the traffic from the LAN device 10.0.1.133 to the SMTP mail server 10.66.0.125 through the SD-WAN member ID 1 or 2.

D. FortiGate steers the traffic from the LAN device 10.0.1.133 to the company SMTP mail server
10.66.0.125 through the SD-WAN member ID 4.

정답: C

설명: (DumpTOP 회원만 볼 수 있음)

문제4

Which two statements correctly describe what happens when traffic matches the implicit SD-WAN rule? (Choose two.)

A. Traffic is load balanced using the algorithm set for the v4-ecmp-modesetting.

B. The traffic is distributed, regardless of weight, through all available static routes.

C. The session information output displays no SD-WAN service id.

D. Traffic does not match any of the entries in the policy route table.

E. FortiGate flags the session with may_dirtyand vwl_default.

정답: C,D

설명: (DumpTOP 회원만 볼 수 있음)

문제5

Which three factors about SLA targets and SD-WAN rules should you consider when configuring SD-WAN rules? (Choose three.)

A. When configuring an SD-WAN rule, you can select multiple SLA targets from different performance SLAs.

B. SD-WAN rules can use SLA targets to check whether the preferred members meet the SLA requirements.

C. Member metrics are measured only if a rule uses the SLA target.

D. When configuring an SD-WAN rule, you can select multiple SLA targets if they are from the same performance SLA.

E. SLA targets are used only by SD-WAN rules that are configured with a Lowest Cost (SLA) strategy.

정답: A,B,E

설명: (DumpTOP 회원만 볼 수 있음)

문제6

You have a FortiGate configuration with three user-defined SD-WAN zones and two members in each of these zones. One SD-WAN member is no longer in use in health-check and SD-WAN rules. You want to delete it.
What happens if you delete the SD-WAN member from the FortiGate GUI?

A. FortiGate displays an error message. SD-WAN zones must contain at least two members

B. FodiGate accepts the deletion and removes routes as required.

C. FortiGate displays an error message. You must use the CLI to delete an SD-WAN member.

D. FortiGate accepts the deletion and places the member in the default SD-WAN zone.

정답: B

설명: (DumpTOP 회원만 볼 수 있음)

문제7

The SD-WAN overlay template helps to prepare SD-WAN deployments. To complete the tasks performed by the SD-WAN overlay template, the administrator must perform some post-run tasks.
What are two mandatory post-run tasks that must be performed? (Choose two.)

A. Assign an sdwan_id metadata variable to each device (branch and hub).

B. Assign a hub id metadata variable to each hub device.

C. Create policy packages and assign them to the branch devices.

D. Configure routing through the overlay tunnels created by the SD-WAN overlay template.

E. Configure SD-WAN rules.

정답: C,E

설명: (DumpTOP 회원만 볼 수 있음)

문제8

Refer to the exhibit. The administrator used the SD-WAN overlay template to prepare an IPsec tunnels configuration for a hub-and-spoke SD-WAN topology. The exhibit shows the FortiManager installation preview for one FortiGate device.
Based on the exhibit, which statement best describes the configuration applied to the FortiGate device?

A. It is a hub device. It will automatically discover the spoke devices and add them to the SD-WAN topology.

B. It is a spoke device that establishes dynamic IPsec tunnels to the hub. The local subnet range is
10.10.128.0/23.

C. It is a spoke device that establishes dynamic IPsec tunnels to the hub It can send ADVPN shortcut requests.

D. It is a hub device. It can send ADVPN shortcut offers.

정답: D

설명: (DumpTOP 회원만 볼 수 있음)

최신 FCSS_SDW_AR-7.4 무료덤프 - Fortinet FCSS - SD-WAN 7.4 Architect

우리와 연락하기

유용한 링크

최신 업데이트