최신 FCSS_NST_SE-7.6 무료덤프 - Fortinet FCSS - Network Security 7.6 Support Engineer

문제1

Which three common FortiGate-to-collector-agent connectivity issues can you identify using the FSSO real- time debug? (Choose three.)

A. Refused connection. Potential mismatch of TCP port.

B. Incompatible collector agent software version.

C. Mismatched pre-shared password.

D. Log is full on the collector agent.

E. Inability to reach IP address of the collector agent.

정답: A,C,E

문제2

Refer to the exhibit, which contains partial output from an IKE real-time debug.

The administrator does not have access to the remote gateway.
Based on the debug output, which configuration change the administrator make to the local gateway to resolve the phase 1 negotiation error?

A. In the phase 1 proposal configuration, add AES128-SHA128 to the list of encryption algorithms.

B. In the phase 1 proposal configuration, add AES256-SHA256 to the list of encryption algorithms.

C. In the phase 1 proposal configuration, add AESCBC-SHA2 to the list of encryption algorithms.

D. In the phase 1 network configuration, set the IKE version to 2.

정답: B

문제3

Which two statements are true regarding heartbeat messages sent from an FSSO collector agent to FortiGate?
(Choose two.)

A. The heartbeat messages can be seen using the command diagnose debug authd fsso list.

B. The heartbeat messages can be seen on FortiGate using the real-lime FSSO debug.

C. The heartbeat messages must be manually enabled on FortiGate.

D. The heartbeat messages can be seen in the collector agent logs.

정답: B,D

문제4

Which statement about parallel path processing is correct (PPP)?

A. Software configuration has no impact on PPP.

B. PPP does not apply to packets that are part of an already established session.

C. PPP chooses from a group of parallel options lo identity the optimal path tor processing a packet.

D. Only FortiGate hardware configurations affect the path that a packet takes.

정답: C

문제5

Refer to the exhibit, which shows the output of a policy route table entry.

Which type of policy route does the output show?

A. An ISDB route

B. A regular policy route

C. An SD-WAN rule

D. A regular policy route, which is associated with an active static route in the FIB

정답: A

문제6

Refer to the exhibit, which shows the output o! the BGP database.

Which two statements are correct? (Choose two.)

A. The advertised prefix of 10.20.30.0'24 was configured using the network command.

B. The advertised prefix of 10.20.30.0'24 is being advertised through the redistribution of another routing protocol.

C. The first four prefixes are being advertised using a legacy route advertisement.

D. The output shows all prefixes advertised by all neighbors as well as the local router.

정답: A,D

문제7

Refer to the exhibit, which shows the partial output of a real-time OSPF debug.

Why are the two FortiGate devices unable to form an adjacency?

A. The passwords on the FortiGate devices do not match.

B. The Hello packet is being sent from an OSPF router with ID 0.0.0.112.

C. One FortiGate device is configured to require authentication, while the other is not.

D. The two FortiGate devices attempting adjacency are in area 0.0.0.0.

정답: C

최신 FCSS_NST_SE-7.6 무료덤프 - Fortinet FCSS - Network Security 7.6 Support Engineer

우리와 연락하기

유용한 링크

최신 업데이트