최신 Civil-Engineering-Technology 무료덤프 - CTTAM Technical Examination - Civil Engineering Technology C.E.T
For a land development project to be initiated, which of the following documents must be submitted to the municipality for approval?
정답: A
A road to be filled is 6 m wide with 3:1 side slopes and a maximum of 6 m fill at the road centre line. The cut and fill are symmetrical, as shown in the image below. The cost of moving material is $4.00 per m³ per km haul length. What is the minimum cost to fill in the road?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
What documents must a contractor submit as part of a project to consultants for review?
정답: B
설명: (DumpTOP 회원만 볼 수 있음)
Which structural components are indicated by the letters A, B, C, and D in the image below?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
Which of the following illustrates a cantilever?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
A geotechnical report indicates the presence of a peat layer in several boreholes. The peat layer ranges in thickness from 450 mm to 1200 mm and is found at a depth of 1.5 m below the existing grade. How should this be addressed in the project specifications that are being prepared?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)
Considering Occupational Health and Safety standards for trench side slopes in lieu of shoring, and a 1.2 m wide trench, what is the minimum offset from centre line to the top edge of the trench for an excavation that is
3 m deep?
3 m deep?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
A continuous bridge spans over multiple piers. If one of the piers collapsain standing because the adjacent piers will pick up the load. What type of redundancy does the bridge have?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)