최신 API-570 무료덤프 - API Piping Inspector

A. the purchasing department

B. inspector

C. piping engineer

D. repair organization

A. Dead legs

B. Valves

C. Fittings

D. Straight Run Pipe

A. ASME 816.5

B. API RP 2207 Section 2

C. API RP 579, Section 11

D. API 598, Section 1

A. 3 feet -5. feet

B. Any length as long as It IS Inspected full circumference.

C. 6 feet -8 feet.

D. Any length as long as it is inspected 180° circumference.

A. 0.11"

B. 1.1"

C. Not enough information given

D. 0.06"

A. ASM E Section V

B. ASME Section IX

C. ASNT SNT- TC-1A

D. API 570

A. When the production weld is radiographed

B. When the job contract gives authorization

C. When there is specific approval of the inspector

D. When the procedure is used only one time

A. Less corrosive than higher resistivity soils.

B. More desirable because of increased electrolyte.

C. More corrosive than higher resistivity soils

D. Has no effect on corrosion.

A. Rust or corrosion might be holding the pressure

B. The joint might be unscrewed

C. The craftsman should not be near the threaded connection

D. A crack in a thread root might fail

A. A device taped to the pipe that will record temperature variations

B. A vibration device that generates heat through friction producing a stress relieved weldment

C. A flammable material that, when ignited, will create enough heat to stress relieve piping

D. A device used to check the heat treatment temperature, usually connected by capacitor discharge welding