최신 4A0-104 무료덤프 - Alcatel-Lucent Services Architecture

A. All of the above

B. To replicate traffic from a service port to another port for debugging or monitoring functions

C. To utilize unused ports of a service router until they are required for a service.

D. To mirror service requirements of a customer with a single branch office and multiple remote sites

E. To ease the configuration burden of services that support a large number of subscribers

A. Traffic is flooded to all SAPs in the service.

B. Traffic is flooded to all SAPs and spoke SDPs in the service.

C. The traffic is not flooded.

D. Traffic is flooded to all SAPs and mesh SDPs in the service.

E. Traffic is flooded to all SAPs, spoke SDPs, and mesh SDPs in the service.

A. E-pipe

B. A-pipe

C. F-pipe

D. C-pipe

A. 1540

B. 1548

C. 1556

D. 1520

A. Traffic is flooded to all SAPs in the service.

B. Traffic is flooded to all SAPs and spoke SDPs in the service.

C. The traffic is not flooded.

D. Traffic is flooded to all SAPs, spoke SDPs. and mesh SDPs in the service.

E. Traffic is flooded to all SAPs and mesh SDPs in the service.

A. Service ID

B. SDPID

C. VC-ID

D. Customer ID

E. SAPID

A. A mirror source with a defined source type.

B. A mirror source defined with an SDP destination.

C. A mirror destination and a mirror source with the same service I

D. A mirror destination with a SAP defined.

A. Set the MTU of the IES's network port to match the service MTU of the VPLS.

B. Set the SDP MTU of the IES to match the SDP MTU of the VPLS.

C. Set the ip-mtu of the IES to match the service MTU of the VPLS.

D. Set the service MTU of the VPLS to match the IES MTU.

A. 4078

B. 4986

C. 5014

D. 5022

A. All services bound to the same SDP will have the same transport encapsulation.

B. Any operation on an SDP will affect all services bound to that SDP.

C. All services bound to the same SDP must be the same service type.

D. An SDP is used to direct traffic for a service from one router to another.

A. All of the above can be used as a mirror source.

B. ASAP.

C. Entries that match an IP filter.

D. Entries that match a MAC filter.

E. A physical port.

F. Ingress MPLS frames with a specific label.

A. 10.10.10.1 has a different service MTU set.

B. 10.10.10.1 has not sent a label to router R4 yet.

C. The SDP to 10.10.10.1 on router R4 is shutdown.

D. Router R4 has not sent a label to router R1(10.10.10.1) yet.

A. They can simplify the implementation of security policy enforcement and packet inspection.

B. They can be used to work around physical topologies that prevent a fully meshed deployment.

C. They reduce the number of SDPs that need to be configured.

D. They prevent loops that can be introduced by mesh deployments.

A. They are used to identify the VRF table for a prefix at the receiving PE.

B. They are used by VPRNs to control the distribution of VPN routing information.

C. They are distributed to all PEs and CEs that are part of the VPRN.

D. They are distributed to PEs to identify the VRF table that a VPN-IPv4 prefix is associated with.

A. BGP

B. IS-IS

C. OSPF

D. RIP

A. configure service sdp sdp-id create

B. configure router sdp sdp-id

C. configure service gre sdp sdp-id create

D. configure service sdp sdp-id mpls create

E. configure service mpls sdp sdp-id create

A. Flooding ensures that all PEs in a fully-meshed VPLS will learn the source address of all traffic.

B. Multiple VPLSes on the same PE share the same MAC FDB.

C. The PE routers of the service are responsible for learning MAC addresses.

D. MAC learning reduces flooding of frames with previously learned addresses.

A. To determine the presence of hosts using the service

B. To determine the service MTU of the service using an SDP.

C. To determine the path MTU to the far-end IP address over an SDP.

D. To test the ability of reaching the far-end IP address of an SDP within the SDP encapsulation