최신 300-515 무료덤프 - Cisco Implementing Cisco Service Provider VPN Services

A. origin

B. cluster ID

C. local preference

D. originator ID

E. AS_PATH

A. with identical type of service value

B. with no tags

C. with different class of service values

D. with different type of service values

E. of a specific VLAN

A. Add the IP address to the VRF table.

B. Configure static routes for the VRF.

C. Change the source IP address.

D. Remove the VRF from the interface.

A. They redefine the VLAN tag to include classification, forwarding, and QoS using MPLS labels and EXP bits

B. They add an additional tag to VLANs that allows up to two switch ports to use the same globally configured VLAN ID.

C. They separate the classification and forwarding concepts for VLAN tagging which allows multiple switch ports to use the same VLAN ID without it being configured globally.

D. They assign VLAN IDs to VTP domains so that the same VLAN ID are used more than once globally.

A. Disable split horizon to allow multiple VCs per spoke

B. Disable spanning tree to allow loops to occur within the hub-and-spoke topology.

C. Disable Cisco Discovery Protocol to allow MPLS to share labels between the designated spokes

D. Disable Cisco Discovery Protocol to allow for neighbor discovery

A. Configure static routing on the CE router.

B. Configure the address-family ipv4 labeled-unicast command under the neighbor configuration of the CE router for the PE.

C. Change the rd value to 65001:65001 under the VRF section of the PE router.

D. Configure OSPF on the PE router.

A. by learning IPv4 routes from connected CEs and redistributing them into the global IGP

B. by converting CE routes into VPNv4 routes and exchanging them using the global IGP

C. by establishing BGP neighbor relationships between all connected CEs to exchange routing information

D. by converting CE routes into VPNv4 routes and exchanging them using MP-BGP

A. They are multihoming mechanisms used for CE devices.

B. They are used to provide single connection from a CE device to a service provider.

C. They are both roles that a designated router can take when MPLS is used with EVPN.

D. They are default gateway redundancy options.

A. A system notification is sent to the network administrator that triggers the manual configuration of the new MAC address on PE2 and PE3.

B. The MAC address is entered into the CAM table only if it is learned on the native VLAN.

C. The new MAC address is sent by BGP to PE2 and PE3 as a Type 2 BGP route.

D. The MAC address is entered into the CAM table and is classified for use on the native VLAN