최신 300-425 무료덤프 - Cisco Designing Cisco Enterprise Wireless Networks
An engineer is implementing a wireless design for a service provider. The design includes a Catalyst 9800, a stack of two Catalyst 9300X-48HX switches, and 9166 APs. Each AP must be named using the Floor-439412509-01X sting where X is the area number. The engineer wants to connect the APs to the switch stack using POE. How many APs must the engineer connect to the stack so the APs run using full functionalities?
정답: B
설명: (DumpTOP 회원만 볼 수 있음)
An engineer is designing a network deployment for a technology company. The company has four buildings with access points that must provide seamless wireless coverage and client roaming. The customer data center must have two WLCs and the core switches for the network.
Which type of wireless architecture must be used?
Which type of wireless architecture must be used?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)
An engineer is estimating the loss between two floors of an office building. Using Ekahau, they have measured -45 dBm at the ground level of the floor with the access point and -50 dBm at the ceiling level of the floor below it. Which value is the loss of the floor?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
A network consultant must create a wireless design with these characteristics:
- Provide coverage in a single contiguous space.
- Support dual-band wireless coverage.
- Use nine APs for full coverage in a 5 GHz band.
What must the engineer do to mitigate co-channel interference and maintain coverage in 2.4 GHz?
- Provide coverage in a single contiguous space.
- Support dual-band wireless coverage.
- Use nine APs for full coverage in a 5 GHz band.
What must the engineer do to mitigate co-channel interference and maintain coverage in 2.4 GHz?
정답: B
설명: (DumpTOP 회원만 볼 수 있음)
Refer to the exhibit. A company has a foreign Cisco WLC named WLC1 and two anchor WLCs named WLC2 and WLC3 that all run version 8.10.x code. The company wants to configure the priority for one of the WLANs with WLAN-id #5 so that WLC1 always has WLC2 as its primary anchor for WLAN-id #5. Which command must be incorporated in the design to meet the requirement?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
Which Cisco WLC feature allows grouping of APs into a logical set for RF management?
정답: C
An engineer needs a wireless design to provide redundancy for APs at remote sites that are connected to Cisco 3504 Wireless LAN Controllers. The central Cisco 5520 Wireless LAN Controller supports 2000 APs and has 1975 access points associated to it. The engineer decides that not all APs at the remote sites must remain functional in the event of a failure. How does the engineer ensure that the most important access points at the remote sites remain online while not impacting the main site?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)
An engineer is designing a solution where guests terminate on an anchor controller in the DMZ.
The engineer is having issues and wants to test connectivity between members of a mobility group. Which command must be issued to test whether a mobility control packet is able to be reached over the management interface?
The engineer is having issues and wants to test connectivity between members of a mobility group. Which command must be issued to test whether a mobility control packet is able to be reached over the management interface?
정답: B
설명: (DumpTOP 회원만 볼 수 있음)
Multiple WLCs are implemented in a high-availability configuration in a mobility group. APs are deployed with only a primary controller assigned.
By default, which mobility group member controller do the orphaned APs join in the event of a failed controller?
By default, which mobility group member controller do the orphaned APs join in the event of a failed controller?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)
A customer has two Cisco 550B WLCs that manage all the access points in their network and provide N+1 redundancy and load balancing. The primary Cisco WLC has 60 licenses and the secondary Cisco WLC has 40. The customer wants to convert the N+1 model to an HA model and provide SSO. Configuration must be performed during a maintenance window.
After performing all the configurations on both controllers, the config redundancy unit secondary command is issued on the secondary Cisco WLC and it fails.
Which parameter needs to be in place to complete the configuration?
After performing all the configurations on both controllers, the config redundancy unit secondary command is issued on the secondary Cisco WLC and it fails.
Which parameter needs to be in place to complete the configuration?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
A customer has a central Cisco WLC that manages APs in FlexConnect mode. The wireless infrastructure supports multiple small branches. One branch deploys new CCX wireless phones that are authenticated by a central Cisco ISE via PEAP/IMSCHAPv2, and traffic is switched locally. The customer must reduce the number of full authentication requests and optimize roaming for the new phones. Which action accomplishes the requirement?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
A wireless engineer is performing a post verification of a wireless network.
Which two metrics does the engineer verify to ensure that the wireless network can support voice services? (Choose two.)
Which two metrics does the engineer verify to ensure that the wireless network can support voice services? (Choose two.)
정답: C,D
설명: (DumpTOP 회원만 볼 수 있음)
An engineer is performing a predictive wireless design for a medical treatment environment, which requires data and voice services. What is the minimum requirement for the design?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
An engineer is setting up the WLC to support a high-density design for a lecture hall. The engineer must modify the existing high-density RF profile to obtain a smaller cell size. Also, the clients must connect to the nearest AP using the highest possible data rates. Which setting allows this design?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)
In a multifloor office building that contains an auditorium in the basement, all the access points are joined to the same WLC. The plan is to implement a high-density, high-speed design in the auditorium and a low-density VoWiFi design in the offices. How must the access point groups be configured for the auditorium and the offices?
정답: D