최신 300-410 무료덤프 - Cisco Implementing Cisco Enterprise Advanced Routing and Services
What are two purposes of using IPv4 and VPNv4 address-family configurations in a Layer 3 MPLS VPN?
(Choose two.)
(Choose two.)
정답: B,D
설명: (DumpTOP 회원만 볼 수 있음)
Refer to the exhibit. Which action restores the routes from neighbors while still filtering 1.1.1.0/24?
정답: B
Refer to the exhibit. An engineer applied filter on R1 The interface flapped between R1 and R2 and cleaning the BGP session did not restore the BGP session and failed Which action must the engineer take to restore the BGP session from R2 to R1?
정답: A
Refer to the exhibit.
The network administrator configured the network to connect two disjointed networks and ail the connectivity is up except the virtual link which causes area 250 to be unreachable. Which two configurations resolve this issue? (Choose two.)
The network administrator configured the network to connect two disjointed networks and ail the connectivity is up except the virtual link which causes area 250 to be unreachable. Which two configurations resolve this issue? (Choose two.)
정답: B,E
설명: (DumpTOP 회원만 볼 수 있음)
Refer to the exhibit.
During ISP router maintenance, the network produced many alerts because of the flapping interface. Which configuration on R1 resolves the issue?
During ISP router maintenance, the network produced many alerts because of the flapping interface. Which configuration on R1 resolves the issue?
정답: D
An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)
정답: D,E
Refer to the exhibit.
R1 and R2 are configured for EIGRP peering using authentication and the neighbors failed to come up. Which action resolves the issue?
R1 and R2 are configured for EIGRP peering using authentication and the neighbors failed to come up. Which action resolves the issue?
정답: B
Which option is the best for protecting CPU utilization on a device?
정답: B
Refer to the exhibit. The OSPF neighbor relationship is not coming up What must be configured to restore OSPF neighbor adjacency?
정답: B
Refer to the exhibit. Site1 must perform unequal cost load balancing toward the segments behind Site2 and Site3. Some of the routes are getting load balanced but others are not. Which configuration allows Site1 to load balance toward all the LAN segments of the remote routers?
정답: A
Refer to the exhibit. The remote server is failing to receive the NetFlow data Which action resolves the issue?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
Refer to the exhibit.
The branch router is configured with a default route toward the internet and has no routes configured for the HQ site that is connected through interface G2/0. The HQ router is fully configured and does not require changes. Which configuration on the branch router makes the intranet website (TCP port 80) available to the branch office users?
The branch router is configured with a default route toward the internet and has no routes configured for the HQ site that is connected through interface G2/0. The HQ router is fully configured and does not require changes. Which configuration on the branch router makes the intranet website (TCP port 80) available to the branch office users?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?
정답: B
Refer to the exhibit R2 has been receiving routes from R4 that originated outside AS300 A network engineer configured an AS-Path ACL to avoid adding these routes to the R2 BGP table but the routes are still present in the R2 routing table Which action resolves the issue?
정답: A