최신 N10-008 무료덤프 - CompTIA Network+ Certification
Which of the following routing protocols uses an autonomous system number?
정답: A
A building is equipped with light sensors that turn off the fluorescent lights when natural light is above a certain brightness. Users report experiencing network connection issues only during certain hours. The west side of the building experiences connectivity issues in the morning hours and the east side near the end of the day. At night the connectivity issues affect the entire building. Which of the following could be the cause of the connectivity issues?
정답: B
Which of the following uses the destination IP address to forward packets?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
A user cannot connect to the network, although others in the office are unaffected. The network technician sees that the link lights on the NIC are not on. The technician needs to check which switchport the user is connected to, but the cabling is not labeled. Which of the following is the best way for the technician to find where the computer is connected?
정답: D
A technician must install and configure a network device in a building with 20 classrooms. Each room must be on a separate subnet and should not be able to see traffic from other subnets.
Which of the following is the MOST cost-effective solution?
Which of the following is the MOST cost-effective solution?
정답: D
A technician is configuring a network switch to be used in a publicly accessible location. Which of the following should the technician configure on the switch to prevent unintended connections?
정답: D
Which of the following would be the MOST cost-effective recovery solution for a company's lower- priority applications?
정답: A
설명: (DumpTOP 회원만 볼 수 있음)
A Wi-Fi network was recently deployed in a new, multilevel building. Several issues are now being reported related to latency and drops in coverage. Which of the following is the first step to troubleshoot the issues?
정답: B
A network engineer is investigating reports of poor network performance. Upon reviewing a report, the engineer finds that jitter at the office is greater than 10ms on the only WAN connection available. Which of the following would be MOST affected by this statistic?
정답: C
A network administrator needs to back up the configurations of all network devices and store the configurations off-line until they are needed. Which of the following should the administrator use to back up the configurations securely?
정답: A
Which of the following OSI model layers is where conversations between applications are established, coordinated, and terminated?
정답: B
설명: (DumpTOP 회원만 볼 수 있음)
A company is reviewing ways to cut the overall cost of Its IT budget. A network technician suggests removing various computer programs from the IT budget and only providing these programs on an as-needed basis. Which of the following models would meet this requirement?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
A technician is concerned about unauthorized personnel moving assets that are installed in a data center server rack. The technician installs a networked sensor that sends an alert when the server rack door is opened. Which of the following did the technician install?
정답: D
A Wi-Fi network was recently deployed in a new, multilevel building. Several issues are now being reported related to latency and drops in coverage. Which of the following is the FIRST step to troubleshoot the issues?
정답: D
설명: (DumpTOP 회원만 볼 수 있음)
A company needs a redundant link to provide a channel to the management network in an incident response scenario. Which of the following remote access methods provides the BEST solution?
정답: C
설명: (DumpTOP 회원만 볼 수 있음)
An attacker is using an unknown vulnerability that allows malicious actors to utilize the print spooler to gain system privileges on a computer. Which of the following is this scenario an example of?
정답: C
Which of the following does OSPF use to communicate routing updates?
정답: D
Hotspot Question
A network technician needs to resolve some issues with a customer's SOHO network. The customer reports that some of the PCs are not connecting to the network, while others appear to be working as intended.
INSTRUCTIONS
Troubleshoot all the network components.
Review the cable test results first, then diagnose by clicking on the appropriate PC, server, and Layer 2 switch.
Identify any components with a problem and recommend a solution to correct each problem.
If at any time you would like to bring back the initial state of the simulation, please dick the Reset All button.
A network technician needs to resolve some issues with a customer's SOHO network. The customer reports that some of the PCs are not connecting to the network, while others appear to be working as intended.
INSTRUCTIONS
Troubleshoot all the network components.
Review the cable test results first, then diagnose by clicking on the appropriate PC, server, and Layer 2 switch.
Identify any components with a problem and recommend a solution to correct each problem.
If at any time you would like to bring back the initial state of the simulation, please dick the Reset All button.
정답:
Which of the following is used to ensure traffic flows efficiently on multiple T-1 circuits?
정답: C
Which of the following layers of the OSI model is between the Data Link and Transport layers?
정답: A