최신 200-401 무료덤프 - Cisco Managing Industrial Networks with Cisco Networking Technologies

A. FastEthernet1/3

B. FastEthernet1/1

C. FastEthernet1/4

D. FastEthernet1/2

E. FastEthernet1/5

A. It measures light-pulse width to measure that all pins are correctly connected.

B. It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices, bridge taps, split pairs, and other problems.

C. It performs wiremapping to measure that all pins are correctly connected.

D. It correlates the returned light pulses with a location in the fiber.

A. Any problem which leaves the network inoperable can be traced to the central hub.

B. This network type requires less cable as compared to linear bus topology.

C. Disruption of the entire network is not required when adding new machines.

D. The performance of the entire network is directly dependent on the performance of the hub.

E. The performance of one of the numerous nodes cannot reflect on the performance of other nodes.

A. These commands need to be added to the configuration:C-router(config)# router ospf 1C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0

B. These commands need to be added to the configuration:C-router(config)# router ripCrouter(config-router)# network 172.19.0.0

C. No further routing configuration is required.

D. These commands need to be added to the configuration:C-router(config)# router eigrp 123C-router(config-router)# network 172.19.0.0

A. designated ports

B. root bridge

C. fast mode ports

D. BDPU priority

E. root ports

F. duplex operating mode

A. to create a default route

B. to maintain a loop-free Layer 2 network topology

C. to enhance the functions of SNMP

D. to prevent routing loops

E. to provide multiple gateways for hosts

A. SNMP

B. Telnet

C. HTTP

D. RMON

E. SSH